3.OPERATION
Adjusting and Setting (Adjustment)
Source Registry
On Source Registry
The projector uses a
This function registers these video signals in the Source Select list and at the same time obtains the various parameters pertaining to these signals. Always access this mode first whenever inputting video signals for the first time so that you can register
the video signals before making any adjustments. If the current input signal(s) has not been registered, the “New Signal” message is displayed on screen.
NOTE: If you have software which changes scanning mode due to the graphic board of your PC (such as VGA), it will be necessary to register signal entry for each scanning mode. This can be done using your PC by way of stopping the software in each scanning mode and performing a signal entry operation.
■Source Registry
When connecting a signal for the first time, you need to register it into the projector’ s memory. You can copy the initial setting for the new signal from any other signal that has already been registered or use the factory preset setting.
To make the signal entry, proceed as follows:
1Press the ADJUST button.
• The Adjust menu is displayed.
2Use the CURSOR 
or 
button to highlight the “1.Source Registry” line and press ENTER.
•The Source Registry menu will be displayed.
•You can also select the Source Registry menu directly by pressing the INPUT “1” button.
- A d j u s t m e n t -
1 . S o u r c e R e g i s t r y
2 . A m p l i t u d e
3 . W h i t e B a l a n c e
4 . S i g n a l L e v e l
5 . U n i f o r m i t y
6 . D i s p l a y F u n c t i o n
7 . L a m p M o d e
8 . S e t O p t i o n
- S o u r c e R e g i s t r y - 1 . N e w R e g i s t r y
2 . R e g i s t r y E d i t
43