16.2 Emptying the tray
TRAY / EMPTY
If this message appears on the display, you can no longer draw off espresso. You must empty the capsule container first.
Carefully take out the drip tray and the capsule container, it is filled with water.
NO / TRAY
Empty the drip tray and the capsule container and install it in the machine again.
READY
The yellow water level indicator appears when the drip tray is full.
16.3 Replacing the filter
After drawing off 50 litres or after 2 months, the filter car- tridge will be used up.
Refer to Chapter 6.2 «Replacing the filter».
If your machine is disconnected from power supply, the time is not measured. A message requesting you to replace the filter will appear on the display
16.4 Unit calcified
During operation, the machine will calcify. The degree of scaling depends on the hardness of the water in your region. The machine will inform you when
SCALED / READY
16.5 General cleaning instructions
Never use scrapers, abrasive cloths, sponges or caustic chemicals for cleaning.
Clean the inside and outside of the case using a soft, moist cloth.
Clean the replaceable hot water jet and steam/frothing jet after each use.
After heating milk, draw off some water to clean the inside of the pivoting jet.
Disassemble the steam/frothing jet for proper cleaning (Fig. 9).
Clean the display dialog system / control panel with a micro- fibre cloth.
The water tank should be rinsed daily and refilled with fresh water.
If | E |
mercial | |
take it out of the machine. |
Remove the Claris plus filter cartridge, if applicable, before
17. De-scaling
The machine features an integrated
Your machine will inform you if it needs
You can still draw off coffee or hot water / steam and start the
Switch off the system before starting the
17
