NETGEAR 2.4 GHz MA111 manual 0682, Troubleshooting, CE Declaration of Conformity, Problem, Cause

Troubleshooting

Problem	Cause	Solution
No lights are lit	The Wireless USB Adapter	• Remove and reinsert the Wireless
on the Wireless	is not inserted properly into	USB Adapter.
USB Adapter.	the USB port on your PC.	• Check the device manager in Windows to
	Or the proper MA111
		see if the adapter card is properly
	Wireless USB Adapter
		recognized in the Windows operating
	driver is not loaded.
		system. Reload the driver if necessary.
		• Try to install the Wireless USB Adapter in
		different USB port if it’s available.
The LED is	The Wireless USB Adapter	• The Access Point may not be powered on.
blinking	is not associated to any	• The Access Point and the MA111 Wireless
repeatedly.	Access Point properly. You
		USB Adapter are not configured with the
	may not have configured	same wireless parameters. Check the SSID,
	the wireless parameters of
		and WEP encryption settings.
	the wireless nodes to be the
		• The Access Point may be out of range. Try
	same as the Access Point.	moving the system closer to the Access Point
		or readjusting the antenna on the Access
		Point. You may also move the Access Point
		to a higher location for better signal
		reception by the Wireless USB Adapter.
I am associated	This could be a physical	• Check to make sure that the Access Point
and connected	layer problem or a network	is physically connected to the Ethernet
to an Access	configuration problem.	network.
Point, but I		• Make sure that the IP addresses and the
cannot see the
		Windows networking parameters are all
other computers
		configured correctly.
on the Ethernet
side of the
network.

CE Declaration of Conformity

For the following equipment:
Wireless USB Adapter	0682 !
MA111

is herewith confirmed to comply with the requirements set out in the Council Directive on the Approximation of the Laws of the Member States relating to Electromagnetic Compatibility and Radio Spectrum Matters (99/5/EC), Low-voltage Directive (73/23/EEC) and the Amendment Directive (93/68/EEC). For the evaluation regarding the Directives, the following standards were applied:

•EN 60950: 2000

•EN 301 489-17 V1.1.1:09-2000

•EN 301 489-1 V1.3.1:09-2001

•EN 300 328-1 V1.3.1: 12-2001

•EN 300 328-2 V1.2.1: 12-2001

Déclaration de conformité CE

Il est certifié que l’équipement suivant :

Wireless USB Adapter	0682 !
MA111

est conforme aux exigences définies par la Directive du Conseil concernant le rapprochement des législations des États Membres relatives à la compatibilité électromagnétique (99/5/EC), la Directive sur les basses tensions (73/23/CEE) et la Directive d’amendement (93/68/CEE). Les normes suivantes ont été appliquées pour évaluer la conformité à ces Directives :

•EN 60950: 2000

•EN 301 489-17 V1.1.1:09-2000

•EN 301 489-1 V1.3.1:09-2001

•EN 300 328-1 V1.3.1: 12-2001

•EN 300 328-2 V1.2.1: 12-2001

23