Manuals / Brands / Computer Equipment / Network Router / NETGEAR / Computer Equipment / Network Router

NETGEAR DG834Gv5 Table2. Factory Default Configuration Settings (continued)

1 44

Download 44 pages, 745.96 Kb

Technical Specifications and Default Configuration 35

Wireless

Wireless communication Enabled

SSID name NETGEAR

Security Disabled

Broadcast SSID Enabled

Transmission speed Autoa

Country/region United States (in North America; otherwise, varies by

region)

RF channel 11 until the region is selected

Operating mode 54 Mbps

Data rate Best

Output power Full

Access point Enabled

Authentication type Open system

Wireless card access list All wireless stations allowed

a. Maximum Wireless signal rate derived from IEEE Standard 802.11 specifications. Actual throughput will vary.

Network conditions and environmental factors, including volume of network traffic, building materials and

construction, and network overhead, lower actual data throughput rate.

Table2. Factory Default Configuration Settings (continued)

Feature Default Behavior

Contents

Main Page Contents ADSL2+ Modem Wireless Router Setup Manual Page Getting to Know Your Wireless Router Unpacking Your New Router Hardware Features You can use the LEDs to verify various conditions. The following table describes each LED.. Front Panel The wireless modem router front panel shown below contains status LEDs. Figure 1 Table 1. LED Descriptions Back Panel The back panel of the wireless modem router contains port connections described below. Figure 2 Table 1. LED Descriptions (continued) Router Side Panel Router Label Positioning Your Wireless Router Installing Your Wireless Modem Router Page Page Installing Your Router Using the Smart Wizard Using the Smart Wizard Accessing Your Router After Installation and Checking for New Firmware Installing Your Router Manually (Advanced, Mac, and Linux Users) Understanding ADSL Microfilters ADSL Microfilter ADSL Microfilter with Built-In Splitter Connecting Your Wireless Modem Router Page D Verifying Your Connection Setting Up Your Router for Internet Access Page Page Configuring Your Wireless Network Specifying Wireless Settings Setting Your SSID and Wireless Security Manually Using Push 'N' Connect (WPS) to Configure Your Wireless Network Page Page Page Troubleshooting Basic Functioning Power LED Not On Power LED is Red LAN or Internet Port LEDs Not On Troubleshooting the Web Configuration Interface Troubleshooting the ISP Connection ADSL link Obtaining an Internet IP Address Troubleshooting PPPoE or PPPoA Troubleshooting Internet Browsing Troubleshooting a TCP/IP Network Using the Ping Utility Testing the LAN Path to Your Router Testing the Path from Your Computer to a Remote Device Restoring the Default Configuration and Password Resetting to Factory Default Settings Technical Specifications and Default Configuration General Specifications The following table lists technical specification for the wireless modem router. Default Configuration Table2. Factory Default Configuration Settings Table2. Factory Default Configuration Settings (continued) Page Related Documents Page Registration and Certifications Product Registration, Support, and Documentation Maximum Wireless Signal Rate Derived from IEEE Standard 802.11 Specifications Federal Communications Commission (FCC) Compliance Notice: Radio Frequency Notice