NETGEAR DG834Gv5 Default Configuration

34 Technical Specifications and Default Configuration

Default Configuration

You can use the reset button located on the rear panel of your Wireless ADSL2+ Modem Router to

reset all settings to their factory defaults. This is called a hard reset. To perform a hard reset, push

and hold the reset button for three seconds. Your Wireless ADSL2+ Modem Router will return to

the factory configuration settings shown in the table below.

Table2. Factory Default Configuration Settings

Feature Default Behavior

Router Login

User login URL http://www.routerlogin.net or http://www.routerlongin.com

User name (case sensitive) admin

Login password (case sensitive) password

Internet Connection

WAN MAC address Use default address

WAN MTU size 1500

Port Speed AutoSense

Local Network (LAN)

Lan IP 192.168.0.1

Subnet mask 255.255.255.0

DHCP server Enabled

DHCP starting IP address 192.168.0.2

DHCP ending IP address 192.168 .0 .254

DMZ Disabled

Time zone GMT

Time zone adjusted for daylight saving

time Disabled

Firewall

Inbound (communications coming in from

the Internet) Disabled (except traffic on port 80, the http port)

Outbound (communications going out to

the Internet) Enabled (all)

Source MAC filtering Disabled

Contents

Main Page Contents ADSL2+ Modem Wireless Router Setup Manual Page Getting to Know Your Wireless Router Unpacking Your New Router Hardware Features You can use the LEDs to verify various conditions. The following table describes each LED.. Front Panel The wireless modem router front panel shown below contains status LEDs. Figure 1 Table 1. LED Descriptions Back Panel The back panel of the wireless modem router contains port connections described below. Figure 2 Table 1. LED Descriptions (continued) Router Side Panel Router Label Positioning Your Wireless Router Installing Your Wireless Modem Router Page Page Installing Your Router Using the Smart Wizard Using the Smart Wizard Accessing Your Router After Installation and Checking for New Firmware Installing Your Router Manually (Advanced, Mac, and Linux Users) Understanding ADSL Microfilters ADSL Microfilter ADSL Microfilter with Built-In Splitter Connecting Your Wireless Modem Router Page D Verifying Your Connection Setting Up Your Router for Internet Access Page Page Configuring Your Wireless Network Specifying Wireless Settings Setting Your SSID and Wireless Security Manually Using Push 'N' Connect (WPS) to Configure Your Wireless Network Page Page Page Troubleshooting Basic Functioning Power LED Not On Power LED is Red LAN or Internet Port LEDs Not On Troubleshooting the Web Configuration Interface Troubleshooting the ISP Connection ADSL link Obtaining an Internet IP Address Troubleshooting PPPoE or PPPoA Troubleshooting Internet Browsing Troubleshooting a TCP/IP Network Using the Ping Utility Testing the LAN Path to Your Router Testing the Path from Your Computer to a Remote Device Restoring the Default Configuration and Password Resetting to Factory Default Settings Technical Specifications and Default Configuration General Specifications The following table lists technical specification for the wireless modem router. Default Configuration Table2. Factory Default Configuration Settings Table2. Factory Default Configuration Settings (continued) Page Related Documents Page Registration and Certifications Product Registration, Support, and Documentation Maximum Wireless Signal Rate Derived from IEEE Standard 802.11 Specifications Federal Communications Commission (FCC) Compliance Notice: Radio Frequency Notice