NETGEAR GS748T manual LED Designations, Port LEDs, System LED

GS748T Gigabit Smart Switch

LED Designations

Port LEDs

The following table describes the RJ-45, combo, and dedicated SFP port LED designations. There are two LEDs for each RJ-45 port. Each SFP port has its own indication LED.

LED	Designation
Link/Speed/ACT LED mode for	•	Off—No link established.
copper ports 1 to 48:	•	Solid Green—A valid 1000 Mbps link is established.
	• Blinking Green—The port is transmitting or receiving packets at
		1000 Mbps.
	•	Solid Yellow—A valid 10/100 Mbps link is established.
	• Blinking Yellow—The port is transmitting or receiving packets
		at 10/100 Mbps.
	If the media for ports 47 and 48 changes to SFP, the port LED for copper
	ports 47 and 48 changes to off.
Link/ACT LED for SFP ports	•	Off—No SFP module link is established
47 to 50:	•	Solid Green—A valid 1000 Mbps SFP module link is established.
	•	Blinking Green— The port is transmitting or receiving packets
		at 1000 Mbps.
	If the media for ports 47 and 48 changes to copper, the port LED for the
	SFP combo ports changes to off.

System LED

The following table describes the system LED designations.

LED	Designation
Power	•	Green—Device is powered on, run-time code is up and running
	•	Off—Power is not supplied to the device

11