NETGEAR RN31400-100NAS, RN10223D-100NAS To reconfigure your RAID setup 1. Power off the device

NETGEAR ReadyNAS User Guide

The following figure illustrates the default configuration with redundancy in your ReadyNAS NV+.

Figure 3-8

You can switch between the X-RAID Expandable Volume mode and the RAID 0/1/5 Flexible Volume mode only if you want to change the default configuration. It is not necessary to perform this procedure every time you boot up the system. The device remains in the selected mode until explicitly changed.

Warning: Performing a Factory Default will erase all your data on the hard disks.

To reconfigure your RAID setup:

1.Power off the device.

2.Use a paper clip or push pin to press the System Reset switch. Press the System Reset switch for 30 seconds while powering on the device.

The four LEDs will flash for approximately 30 seconds.

3.When the LEDS are on, but not flashing, release the reset switch.

3-8 Maintenance and Administration

v1.0, October 2007