User Manual for the NETGEAR 54 Mbps Wireless USB 2.0 Adapter WG121

WG121 Default Wireless Configuration Settings

If this is a new wireless network installation, use the factory default settings to set up the network and verify wireless connectivity. If this is an addition to an existing wireless network, you will need to identify the wireless configuration and security parameters already defined.

Your NETGEAR 54 Mbps Wireless USB 2.0 Adapter WG121 factory default basic settings are:

Network Name Service Set Identification (SSID): Any (First available network)

Note: In order for the WG121 Wireless USB 2.0 Adapter to communicate with a wireless access point or wireless adapter, all devices must be configured with the same wireless network name (SSID).

Network Mode (Infrastructure or Ad-hoc): Infrastructure

Data security WEP encryption: Disabled

The section below provides instructions for setting up the NETGEAR 54 Mbps Wireless USB 2.0 Adapter WG121 for basic wireless connectivity to an access point. The procedures below provide step-by-step installation instructions for Windows PCs. Use the procedure that corresponds to the version of Windows you are using.

Basic Setup

3-3

Page 27
Image 27
NETGEAR user manual WG121 Default Wireless Configuration Settings