NETGEAR WGE101 WGE101 Bridge Status Lights and Settings

WGE101 Bridge Status Lights and Settings
Status Lights
The WGE101 54 Mbps Wireless Ethernet Bridge has the following three lights, which give you
information about the status of your wireless connection:
PWR Green OFF: No power to the unit.
ON: Power applied to the unit.
WLAN Green OFF: No wireless LAN activity.
Flashing: Searching for an access point or wireless router.
ON: Connected to a wireless LAN.
LAN Green OFF: No Ethernet traffic.
Flashing: Wired Ethernet traffic.
ON: Connected to the Ethernet.
Restoring the Bridge to the Default Settings
There are two ways to return the bridge to its default factory settings.
Using the Default button:
1. Press the Defaultbutton with the point of a pen or pencil for at least 6 seconds until the
WLAN light flashes.
2. Then release the button.
The LAN light and then the WLAN light should each flash and then come on
steadily.
Using the browser-based software:
To use this procedure the bridge must
be connected to a computer — either
directly or through a switch or hub —
that has an Internet browser installed.
1. Open and log into the browser-based
configuration software.
2. Click Restore Factory Defaultin the
navigation bar on the left.
3. Click Restore.
4. When the warning appears, click OK.
5. When the Status page appears, click
Logout.18