N600 Wireless Dual Band Router WNDR3400 Setup Manual
•Internet. The Internet port light (5) should be lit. If it is not, make sure that the Ethernet cable is securely attached to the wireless router Internet port and that the modem, and that the modem is powered on.
•LAN. A LAN light (6) should be lit. Green indicates that your computer is communicating at 100 Mbps; amber indicates 10 Mbps. If a LAN light is not lit, check that the Ethernet cable from the computer to the router is securely attached at both ends, and that the computer is turned on.
Setting Up Your Router for Internet Access
When configuring your wireless router manually, you must log in to your wireless router to set it up initially and to make any changes to your wireless router’s settings later.
The factory default state is reset when you use the Restore Factory Settings button. See “Restoring the Default Password and Configuration Settings” on page 42 for more information.
To access your router:
1.Connect to the wireless router by typing http://www.routerlogin.net in the address field of your browser, and then press Enter.
Figure 10
Connect to the wireless router by typing any one of these three URLs in the address field of your browser, then pressing Enter:
•http://www.routerlogin.net
•http://www.routerlogin.com
•http://192.168.1.1
Installing Your Wireless Router Manually (Advanced and Linux Users) | 17 |
