NETGEAR WNR834Bv2 Default Configuration

Default Configuration 35

Default Configuration

Default Configuration Settings

You can use the Restore Factory Settings button located on the back of your device to reset all

configuration settings to their factory defaults. This is called a hard reset.

• To perform a hard reset, push and hold the Restore button for approximately 5 seconds (until

the POWER LED blinks rapidly). Your device will return to the factory configuration settings

shown in Table 1 below.

• Pressing the Restore button for a shorter period of time will simply cause your device to

reboot.

Table1. Home Router Default Configuration Settings

Feature Default Setting

Smart Wizard Disabled

Router Login

Router Login URL http://www. routerlogin.net;

http://www.routerlogin.com; or http://192.168.1.1

Login Name (case sensitive) admin

Login Password (case sensitive) password

Internet Connection

WAN MAC Address Default hardware address (on label)

MTU Size 1500

Local Network

Router Lan IP address (the Gateway IP

address) 192.168.1.1

IP Subnet Mask 255.255.255.0

DHCP Server Enabled

Time Zone GMT

Contents

Main Page Contents Page Getting to Know Your Wireless Router Unpacking Your New Router Page Hardware Features Figure 3 Figure 4 describes the port connections on the back panel of the wireless router. Front Panel Back Panel Positioning Your Wireless Router Installing Your Wireless Router Updating Your Router Firmware Page Page Installing Your Router Using the Smart Wizard Using the Smart Wizard Accessing Your Router After Installation and Checking for New Firmware Page Page Page Page Installing Your Router Manually (Advanced, Mac, and Linux Users) Connecting Your Wireless Router Page Page Verifying Your Connection Setting Up Your Router for Internet Access Page Checking for New Firmware Page Configuring Your Wireless Settings and Security Options Page Setting Up Your Wireless Computers Page Troubleshooting Basic Setup Checklist Checking Basic Router Functions Troubleshooting Login Problems Checking the Internet Service Connection Obtaining an Internet IP Address Troubleshooting PPPoE Troubleshooting Internet Browsing Using the Ping Utility to Troubleshoot Testing the Path from Your Computer to Your Router Testing the Path from a Computer to the Internet Page Default Configuration Default Configuration Settings Restoring the Default User Name and Password 2. Release the reset button and wait for the router to reboot. located on the rear panel of the router, for about 20 seconds (see Back Panel on page3). Table1. Home Router Default Configuration Settings (continued) Page Page Related Documents Page Registration and Certifications Product Registration, Support, and Documentation Maximum Wireless Signal Rate Derived from IEEE Standard 802.11 Specifications Federal Communications Commission (FCC) Compliance Notice: Radio Frequency Notice