Netopia 4652 manual DSL port Ethernet ports Console port Power port

2-10 Getting Started Guide

Netopia 4652 back panel

Ethernet

DSL 4 3 2 1 Console Power

DSL port		Ethernet ports	Console port	Power port
.
Port			Description
DSL port	An RJ-48 jack labeled DSL for your SDSL or IDSL connection. The Netopia 4652
	supports connections to either SDSL or IDSL lines.
Ethernet ports	Four RJ-45 10/100Base-T Ethernet jacks. You will use any one of these to configure the
	Netopia 4652. For a new installation, use an Ethernet connection. Alternatively, you can
	use the console connection to run console-based management using a direct serial
	connection. You can either connect your computer directly to an Ethernet port using the
	supplied Category 5 Ethernet cable, or connect both your computer and the Netopia
	4652 to an existing LAN environment. All of the ports are auto-sensing, eliminating the
	need for crossover cables.
Console port	A DB-9 console port for a direct serial connection to the console screens. You can use
	this if you are an experienced user. See “Connecting a Console Cable to Your Router” on
	page 5-27.
Power port	A mini-DIN8 power adapter cable connection.

1.Connect the mini-DIN8 connector from the power adapter to the power port, and plug the other end into an electrical outlet.

2.Connect one end of the Category 5 cable to the DSL port, and the other end to your DSL wall outlet.

3.Connect the Ethernet cable to an Ethernet port on the router and the other end to your computer.

You should now have: the power adapter plugged in; the Ethernet cable connected between the router and your computer; and the DSL cable connected between the router and the DSL wall outlet.