![](/images/new-backgrounds/1190956/19095633x1.webp)
Infrared Control (Optional)
Included with
•(1) Infrared Transmitter
•(2) AA Cell Batteries
Instructions
1.Move ON/OFF switch to the ON position.
Select Output First
1.Move ON / OFF switch to the ON position.
1 2 3 4 5
6 7 8 9 10
11 12 13 14 15
16 17 18 19 20
ON 1 2 3 4
5 6 7 8
OFF
9 10 11 12
13 14 15 16
I
N P U T S
O U T P U T S
4. Select one of |
the 20 input |
touch activated |
buttons |
2. Select one of |
the 16 output |
touch activated |
2.Connect the desired output by selecting one of the 16 touch activated buttons.
3.After the output has been selected, be sure the red light on the IR receiver is ON before selecting an input.
Select Input Second
NTI LO BATT
buttons. |
3. Make sure red LED |
on the IR receiver |
is on before selecting |
input. |
4.Connect the desired input by selecting one of the 20 touch activated buttons
Battery Replacement
1.Make sure unit is shut off before replacing battery.
2.Remove slide cover on rear of unit.
3.Remove old batteries carefully.
4.Insert (2) new “AA” cell batteries.
5.Replace slide cover on unit.
Specifications
•50 feet maximum operating range between the transmitter and the front of the matrix switch / infrared receiver. (Line of sight required.)
•Select up to 16 outputs by depressing the touch activated buttons labeled output.
•Select up to 20 inputs by depressing the touch activated buttons labeled input.
•Operates with (2) “AA” batteries.
•LO BATT light indicates low battery at approximately 2.25 volts.
Troubleshooting
PROBLEM | SOLUTION |
IR Remote not selecting | Check battery. Make sure ON / OFF is switched ON. |
input / output |
|
No Audio/Video | Check all cable connections on video source and switch. |
14