Appendix B- General Information
DESCRIPTION | SPECIFICATION |
| |
Dimensions | 19"W x 10" D x 1.75" H |
| |
Operating temperature | 0°C - 55°C (32°F - 131°F) |
| |
Power requirements | 120 or 240VAC @ 50 or 60Hz |
| |
Video bandwidth | 200 MHz (without cables) |
| |
Video sync | TTL |
| |
Chassis material | Aluminum |
| |
Appendix C- Cables |
|
|
|
NTI # |
| DESCRIPTION | |
| Interface PS/2 Keyboard and Mouse and VGA video to | ||
| Interface SUN Keyboard and Mouse and VGA video to | ||
| Interface PS/2 CPU to | ||
| Interface SUN CPU to | ||
Legend: |
|
|
|
MM- male connectors on both ends
If the cable desired is not listed above, please visit our website at http://www.nti1.com for a complete listing of the cables and adapters we offer, or call us at (800)
Appendix D- Rack mounting Instructions
If this NTI switch was designed to be directly mounted to a rack, it includes a mounting flange to make attachment easy. Install 4 captive nuts to the rack in locations that line up with the holes (or slots) in the mounting flange on the NTI switch. Then secure the NTI switch to the rack using four 3/16" diameter screws (not provided). Each screw should be of sufficient length to go completely through the NTI mounting flange, rack frame and fully engage all threads in the captive nut. We suggest installing additional rails to the rack frame to support the weight of the switch. Be sure to tighten all mounting screws securely.
Do not block power supply vents in the NTI switch chassis (if provided) .
Attach all cables securely to the switch and where necessary supply adequate means of strain relief for cables.
Rack
NTI |
| |
| R NETWORK | 1275 Danner Drive Tel: |
| TECHNOLOGIES | Aurora Ohio 44212 Fax: |
| INCORPORATED | www.nti1.com |
|
3/16” Diameter
Screws
Captive Nuts
Support
Rail
22