Network Technologies ST-NXM-U-HD manual Installation, RearViewofST-4X16-U-HD

Installation

Installation

Turn OFF power to all CPUs that will be connected to the NTI ST-nXm-U-HD switch before connecting or disconnecting any cables.

1.If using RS-232 Control see RS-232 section for more information.

2.Connect the monitors to the 15HD female connector ends of the VMTINT-xx or SMTINT-xx cables, depending upon what type of devices will be connected (PS/2 or SUN). See Fig. 1.

3.Connect the keyboards to the purple 6 miniDIN female connector (PS/2) or orange 8 miniDIN female connector (SUN) of the

VMTINT-xx or SMTINT-xx (respectively). If using a PS/2 mouse, connect it to the green 6 miniDIN female connector on the VMTINT-xx cable. See Fig. 1. Insure that the monitors and related keyboards are connected to the same interface cables.

4.Connect the high density male connector end of the cable to a USER x port on the ST-nXm-U-HD switch.

NOTE: If it is desired for only a monitor to be connected to a user port, the device cable end(s) of the VMTINT-xx / SMTINT-xx does not need to be connected to anything.

		CPU
R	U	15
S	S
2	E4	3
3	R	16
2	S

RearViewofST-4X16-U-HD

CPU	CPU	CPU	CPU
13	11	9	7
14	12	10	8

CPU

5

6

CPU

3

4

CPU

1

2

	U
	S
2	1 E
	R
	S

HighDensity 26pinMale

HD15-Female

VMTINT-3/6/10/15/25 (DkBlue)

6mD-Female (Purple-Keyboard)

6mD-Female (Green-Mouse)

VGA

Multi-Scan

Monitor

HighDensity 26pinMale

HD15-Female

SMTINT-3/6/10/15/25 (DkBlue)

ToUSERx porton

NODEMUX-HD

8mD-Female (LightOrange)

PS/2

PS/2Keyboard Mouse

ToaVGA

Multi-Scan

Monitor

ToaSUN

Keyboard/Mouse

Figure 1- Connect devices to switch using interface cables

5.For each CPU: Connect a VMTINT-xx-MM (PS/2 CPU) or SMTINT-xx-MM (SUN CPU) or MMTINT-xx-MM (MAC CPU) cable to the devices port(s) and video port of the CPU as shown in Fig. 2.

NOTE: If the CPU is a SUN type with 13W3 video connector, use an NTI 13W3M-15HDF adapter to connect the SMTINT- xx-MM cable to the CPU.

NOTE: If the CPU only has a serial port for mouse connection (via a com port), a VOPEX-IM9D must be used to convert the signal from the serial port to PS/2 port. Do not use a 9D-to-6mD adapter, it will not work.

NOTE: For USB SUN CPUs, a USB-SUN adapter and a USB-AB-Xm cable must be used to connect the SMTINT-xx-MM cable to the CPU. See Fig. 2.

6.Connect the high density end of each cable to a CPU x port on the ST-nXm-U-HD switch. See Fig. 2.

4