SECTION IV
INSTALLATION OF MODEL 34 (WS)
OPTIONAL WOODEN SURROUND (KIT#PAKDFP34)
NOTE: See page 26, figure 6 for clearances.
(1)When choosing the right location for your heater and surround (mantel) keep the following in mind:
NOTE: Due to high temperatures, this heater should be located out of traffic areas and away from furniture and draperies.
CAUTION: THE INSTALLATION MUST CONFORM TO LOCAL CODES. IN THE ABSENCE OF LOCAL CODES, INSTALLATION MUST CONFORM WITH THE NATIONAL GAS CODES.
NOTE: See Section II for gas hookup and pressure check.
NOTE: See “Producing Adequate Ventilation” page 35.
(2)Position screen before leaving heater unattended.
(3)Instructions for assembly of Wooden Surround (Mantel):
TOOLS NEEDED: Medium Phillips screwdriver, tape measure, power drill, and 5/16" socket.
STEP 1: Lay out all components.
STEP 2: Assemble end panels A & B to top front rail C.
STEP 3: Stand end panels and top front rail onto hearth.
NOTE: (Position back of end panels with back of hearth centering assembly from each end). Install front screws first, then pull back towards the inside to square the mantel. Install screws through back holes.
STEP 4: The owner must decide at this time if parts D, E, and F are to be wood or green. Beginning with panel E stand chosen color face out on hearth flush against stop block located inside end panel A and attach. Position the left end of top window D on top of E and attach. Slide panel F under the right end of D and attach.
STEP 5: Take metal trim panel provided with surround (mantel) and position it on top of heater. Measure 11 1/8" from back of stove, center panel and attach with
STEP 6: Place a cloth or blanket over the front portions of surround (mantel) as not to scar the wooden part of the surround.
28
