THERMOSTAT CONTROL OPERATION 
1.The thermostat control on this heater differs from standard thermostats. Standard thermostats simply turn the burner on and off. The thermostat used on this heater senses the room temperature and adjusts the amount of gas flow to the burner. This will increase or decrease the flame height. At times, the room may exceed the set temperature, which will cause the burner to shut off. When room temperature drops below the thermostat setting, the burner will cycle itself on again. The control knob can be set to any level between “LO” and “HI”.
NOTE: The thermostat sensing bulb measures the temperature of air near the heater cabinet. This may not always agree with room temperature (depending on housing construction, installation location, room size, open air temperatures, etc.). Frequent use of your heater will allow you to determine your personal comfort levels.
MANUAL LIGHTING PROCEDURE
1.If the pilot cannot be lit with the piezo, it can be manually lit with the use of a paper match and a lighter rod.
2.Open access panel door located at bottom front of the appliance.
3.Place the match in the holder and light. With the left hand, turn the control knob
counterclockwise 
to “PILOT”position. Press in gas control knob for fifteen
(15)seconds.
4.Use rod to light match and ignite pilot. The pilot is located in front of the rear log and burner on the right hand side of the appliance.
5.Continue to hold the control knob for an additional one (1) minute to ensure the pilot is lit.
6. | Turn control knob counterclockwise | to the “ON” position. Push the |
| “ON/ OFF” toggle switch to the “ON” position. | The main burner should light. |
7.Close access panel door.
8.Turn on all electrical power to the appliance.
NOTE: This unit may be used with an optional Wall Thermostat. If so, the Wall Thermostat needs to be set at a higher temperature than the room temperature.
18
