NewAir ADW-2600W instruction manual Troubleshooting Tips, Before Calling for Service

8.TROUBLESHOOTING TIPS

Before Calling for Service

Please refer to these troubleshooting tips for possible solutions to minor problems. If the problem persists, please contact an authorized service department or customer service.

	Problem	Possible Causes
	Dishwasher will	A fuse may be blown
	not start.	or the circuit breaker
		may have tripped.
		The power supply
		isn’t turned on.
Technical		Dishwasher door
		hasn’t been properly
Problems		closed.
	Water is not	There’s a kink in the
	pumped out.	drain hose.
		The filter is plugged.
		Kitchen sink is
		plugged.
	Lingering	Wrong detergent
	detergent suds

		Rinse aid was spilled.
	Stains on inside	Detergent with
General	of dishwasher	colorant was used.
Problems	White film on	Hard water
	the inside
	surface
	Cutlery has rust	Your cutlery is not
	stains	corrosion resistant.
		Traces of salt got into
		the wash cycle.
		The lid of the water
		softener container is
		loose.
Noise	Noise in interior	The spray arm is
	of dishwasher	hitting an item in the

What to Do

Replace the fuse or reset your circuit breaker. Turn off other appliances that may be sharing the same circuit.

Make sure that the dishwasher is turned on.

Check to make sure that the power cord is properly plugged into the wall outlet. Re-close the dishwasher door and make sure that it has properly latched.

Check to make sure the drain hose doesn’t have any kinks or bends.

Check the coarse filter to make sure there are no food particles lodged inside. See “Cleaning the Filter.”

Check to make sure that your kitchen sink is draining properly. If not, you may need to contact a professional plumber.

You must use the proper dishwasher detergent to eliminate sud build-up. If suds do accumulate, open the door and allow them to evaporate. Then pour in a gallon of cold water to the bottom of the dishwasher, close the door and turn the machine to the “Soak” cycle to allow the water to drain. Repeat as many times as necessary.

If you do spill rinse aid, make sure to wipe it up immediately to avoid suds.

Use a non-colorant detergent.

Wear rubber gloves and scrub the interior with a damp sponge and dishwasher detergent.

Use corrosion resistant cutlery

After adding dishwasher salt, make sure to run the Quick Wash cycle with an empty load. (Do not choose Turbo cycle if it is an option).

Check lid and make sure it is securely closed.

Pause the wash cycle and rearrange the dishes.

17