-remove protective cap (8, Fig. 1) from emitter tube output window;
-activate LAM in mode C;
-match the center of radiation spot with the aiming mark by means of rotating handwheels of adjustment mechanisms;
-perform test firing with LAM under the same conditions as when checking the weapon fire capability with an iron sight;
-eliminate deviation of the center of impact from the aiming mark. Deviation is measured by adjustment steps: each click of adjustment mechanism corresponds to the shift of radiation spot by 50 mm, when firing at the target situated at a distance of 100 m, i.e. 0.5 mrad;
-fire again after introducing adjustments;
-cover emitter tube output window with protective cap (8, Fig.1).
After adjusted LAM is remounted on the same Picatinny rail of the same weapon new
When firing at a distance to which the weapon with LAM was zeroed, aiming should be performed by pointing radiation spot at the target. When firing at other distances, aiming should be performed in accordance with the table of exceeding the average bullet trajectories above the line of sight.
12
