Trouble Shooting continued
Rotisserie motor will not turn | • | Ensure the motor is connected to a properly grounded | |
|
| power supply. |
|
| • | Ensure the on / off switch is in the on position. |
|
| • | Ensure that the spit is fully inserted into the rotisserie | |
|
| motor |
|
| • | Ensure that the load does not exceed the 40 pound | |
|
| operational capacity. |
|
| • | Ensure that there is no encumbrance or drag. |
|
|
|
|
|
Grill only heats to | • | Check to see if the fuel hose is bent or kinked. |
|
| • | Make sure the grill area is clear of dust. |
|
| • | Make sure the burner and orifices are clean. |
|
| • | Check for spiders and insects. |
|
| • | The regulator has a safety device that restricts the flow of | |
|
| gas in the event of a leak. This safety device can | be |
|
| triggered with out a gas leak. To reset the safety device, | |
|
| turn off all burners and close the LP tank valve. Disconnect | |
|
| the regulator from the LP tank and wait one minute. | |
|
| Reconnect the regulator to the LP tank and slowly open the | |
|
| LP tank valve until the valve is fully open. Light all burners | |
|
| and observe the temperature. |
|
|
|
| |
Grill takes a long time to preheat. | • | Normal preheat | |
|
| Cold weather and wind may effect your preheat time. | |
| • | If you are using volcanic rock or briquettes they can | |
|
| increase the preheat time and maximum temperature. | |
|
|
|
|
Burner flames are not light blue. | • | Too much or not enough air for the flame. |
|
| • | Elevation is the principal cause, however cold weather | |
|
| can affect the mixture. Burner adjustment may be |
|
| • | required. | 38 |
| Grill is in a windy location. | ||
38
