Error Messages

This section lists the error messages that appear in the display.

 

 

 

Message

Solution

0

 

 

 

 

If the subject is too bright, lower ISO

 

 

 

 

 

sensitivity or choose a faster shutter

113, 114,

 

 

 

(Shutter-speed or

speed or smaller aperture (higher f-

115, 131

 

 

 

number).

 

 

 

 

aperture display

 

 

 

 

If the subject is too dark, raise ISO sen-

 

 

 

 

flashes)

62, 113,

 

 

 

 

sitivity, use the built-in flash, or choose

114, 115,

 

 

 

 

a slower shutter speed or larger aper-

 

 

 

 

ture (lower f-number).

131

 

 

 

 

 

 

 

 

Keeping the zoom

A lens with a retractable lens barrel

 

 

 

 

button is attached with the lens barrel

 

 

 

 

ring button pressed,

 

 

 

 

retracted. Press the retractable lens

16, 196

 

 

 

rotate the zoom ring

 

 

 

barrel button and rotate the zoom ring

 

 

 

 

to extend the lens.

 

 

 

 

to extend the lens.

 

 

 

 

 

 

 

 

 

Check lens. Pictures

 

 

 

 

 

can only be taken

Attach a lens.

16

 

 

 

when a lens is

 

 

 

 

 

 

 

 

attached.

 

 

 

 

 

Cannot take pictures.

Turn the camera off and recharge the

 

 

 

 

Insert fully-charged

battery or insert a fully charged spare

11, 13

 

 

 

battery.

battery.

 

 

 

 

Start-up error. Turn

Turn the camera off, remove and

 

 

 

 

the camera off and

replace the battery, and then turn the

13, 17

 

 

 

then on again.

camera on.

 

 

 

 

The clock has been

Set the camera clock.

18, 162

 

 

 

reset.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

No memory card.

Turn the camera off and confirm that

13

 

 

 

the card is correctly inserted.

 

 

 

 

 

 

 

 

This memory card is

Select Yes to format the card, or turn

 

 

 

 

not formatted. Format

the camera off and insert another

13, 157

 

 

 

the memory card?

memory card.

 

 

 

 

Memory card is locked

Turn the camera off and slide the card

14

 

 

 

(write protected).

write-protect switch to the “write”

 

 

 

position.

 

 

 

 

 

 

 

n

 

 

 

 

 

 

 

 

 

 

186