Nikon CP4200 manual Cleaning, 127, Avoid contact with liquid crystal

Cleaning

Lens

One key to cleaning the lens is to not touch it with your fingers. Remove dust or lint with a blower (typically a small device with a rubber bulb attached to one end that you pump to produce a stream of air out the other). To remove fingerprints or other stains that can not be removed with a blower, wipe the lens with a soft cloth, using a spiral motion that starts in the center of the lens and works out to the edges.

Monitor

Remove dust or lint with a blower. To remove fingerprints and other stains, clean the monitor with a soft, dry cloth, being careful not to apply pressure.

Avoid contact with liquid crystal

Should the monitor break, care should be taken to avoid injury due to broken glass and to prevent the liquid crystal from the monitor touching the skin or entering the eyes or mouth.

Body

Use a blower to remove dust and lint, then wipe gently with a soft, dry cloth. After using the camera at the beach or seaside, wipe off any sand or salt with a cloth lightly dampened with fresh water, then dry thoroughly.

Do not use alcohol, thinner, or other volatile chemicals.

Notes on the Monitor

•The monitor may contain a few pixels that are always lit or that do not light. This is a character- istic common to all TFT LCD monitors, and does not indicate a malfunction. Images recorded us- ing the product will not be affected.

•When you frame bright subjects, vertical comet-like streaks that whiten toward either end may appear in the monitor. This phenomenon, known as “smear,” does not appear in the final pho- tograph and does not indicate a malfunction. Some smear may appear in movies.

•Images in the monitor may be difficult to see in a bright light.

•The monitor is lit by an LED backlit. Should the monitor begin to dim or flicker, contact your Ni- kon service representative.

AF-Assist Illuminator

The light-emitting diode (LED) used in the AF-assist illu- minator ( 2) conforms to the following IEC standard:

CLASS 1 LED PRODUCT

IEC60825-1 Edition 1.2-2001

Technical Notes

127