AThe Memory Buffer

The camera is equipped with a memory buffer for temporary storage, allowing shooting to continue while photographs are being saved to the memory card. Up to 100 photographs can be taken in succession; note, however, that frame rate will drop when the buffer is full.

While photographs are being recorded to the memory card, the access lamp next to the memory card slot will light. Depending on the number

of the images in the buffer, recording may take from a few seconds to a few minutes. Do not remove the memory card or remove or disconnect the power source until the access lamp has gone out. If the camera is switched

off while data remain in the buffer, the power will not turn off until all images in the buffer have been recorded. If the battery is exhausted while

k images remain in the buffer, the shutter release will be disabled and the images transferred to the memory card.

ASee Also

For information on choosing the maximum number of photographs that can be taken in a single burst, see Custom Setting d5 (Max. continuous release, pg. 299). For information on the number of pictures that can be

taken in a single burst, see page 423.

88