Nikon S6 manual Error Messages, Storage, Display Problem Solution

Storage

Turn the camera off when not in use. Check that the power-on lamp is off before putting the camera away and remove the batteries if the camera will not be used for an extended period. Do not store the camera with naptha or camphor moth balls or in locations that:

•are next to equipment that produces strong electromagnetic fi elds, such as tele- visions or radios

•are exposed to temperatures below –10 °C (14 °F) or above 50 °C (122 °F)

•are poorly ventilated or subject to humidities of over 60%

To prevent mold or mildew, take the camera out of storage at least once a month. Turn the camera on and release the shutter a few times before putting the camera away again.

Error Messages

The following table lists the error messages and other warnings that appear in the monitor and how to deal with them.

Display	Problem	Solution
(blinks)	Clock not set.	Set clock.	84
	Battery running low.	Prepare to charge or change battery.	10–11
WARNING ! !	Battery exhausted.	Charge or change battery.	10–11
BATTERY EXHAUSTED
		Use focus lock to focus on another sub-
(● blinks red)	Camera cannot focus.	ject at same distance, then recompose	79
		picture.
		Use fl ash, or steady camera using tri-
	Slow shutter speed. Pic-	pod, by placing camera on level sur-	18, 20
(blinks)	tures may be blurred.	face, or by holding camera in both
		hands with elbows against torso.
WARNING ! !	Camera cannot perform
PLEASE WAIT FOR CAMERA		Message clears from display automati-
TO FINISH RECORDING	other operations until	cally when recording is complete.		—
	recording is complete.
MEMORY CARD IS WRITE	Write-protect switch is	Slide write-protect to “write” position.	13
PROTECTED	in “lock” position.
NO CARD PRESENT	No memory card insert-	Insert memory card.	12
	ed in Pictmotion mode.
THIS CARD		• Use approved card.	90
CANNOT BE USED
	Error accessing memory	• Check that connectors are clean.		—
WARNING ! !	card.	• Confi rm that memory card is cor-	12
THIS CARD CANNOT BE READ		rectly inserted.

Technical Notes

93