Niles Audio HDLCR manual Installing a Niles MS-100 Microsensor, Setting the CTR L/R Mode

INSTALLING A NILES MS-100 MICROSENSOR®

1.For each speaker, locate the half-inch round, molded “IR Sensor Knockout” on the baffle.

2.Lay each speaker face down on a clean carpet or rug. Put the tip of a screwdriver into the center of the round “knockout” and sharply tap the screwdriver handle as necessary.

NOTE: TO PREVENT DAMAGE TO THE CROSSOVER NETWORK, ALWAYS REMOVE A KNOCKOUT FROM THE REAR OF THE SPEAKER. DO NOT ATTEMPT TO REMOVE A KNOCKOUT WITH THE SPEAKER FACE UP.

3.At each speaker, install the MS-100 (using its mounting hex nut and washer) until it is tightly secured.

4.Connect all MS-100 wires.

SETTING THE CTR L/R MODE

The HDLCR includes a baffle-mounted CTR L/R mode switch to optimize performance in applications as either a center channel or left/right loudspeaker for front-channel use, as shown in Figure 14.

•For front left- or right-channel applications, slide the HDLCR’s mode switch to L/R.

•For center-channel use, slide the HDLCR’s mode switch to CTR.

Figure 14. The HDLCR’s CTR L/R mode switch.

18