Niles Audio HDLCR manual Removing the Speaker, Specifications

REMOVING THE SPEAKER

After removing the grille, use two small screwdrivers (or needle-nose pliers) to release the snaps that hold the speaker (and baffle) to the frame. Insert the screwdrivers into the holes in the snaps and exert force straight down (towards the woofer) until the snaps release, as shown in Figure 21.

1 - 8 w 1 0 w-80-

w.00B nil-2Uesa89-Y-H

udi44 IF o.34 I co m

Figure 21. Removing the HDLCR speaker baffle from its frame.

Once the snaps release, the speaker can be tilted away from the frame to be removed.

NOTE: DO NOT ATTEMPT TO USE THE FRAME FOR LEVERAGE, AS THIS MAY DAMAGE THE SURFACE OF THE FRAME.

SPECIFICATIONS
Recommended Amplifier Power	Nominal Impedance
10 to 150 watts per channel	4 ohms
Frequency Response	Sensitivity
65 Hz to 21 kHz, +/- 3 dB	89 dB with 2.83 V pink noise input,
	measured at 1 meter on axis
Frame Dimensions	Hole Cut-Out Dimensions
8-1/4" x 14-1/2"	7-1/8" x 13-1/4"
Depth Behind Wall
3-1/2" (based on 1/2" drywall)

Wiring Requirements

We recommend using 16- to 18-gauge speaker wire for runs up to 80 feet and

14-gauge speaker wire for runs up to 200 feet. The connectors will accommodate 12- to 22-gauge wire.

NILES AUDIO CORPORATION – 1-800-BUY-HIFI 23