![trouble-shooting guide](/images/new-backgrounds/13362/1336253x1.webp)
2 Channel, Bridgable Power Amplifiers
trouble-shooting guide
When there is a problem consult this guide first. If the problem persists, or you have additional questions, call your local Niles dealer or call Niles Technical Support at
Symptom | Possible Causes and Test Procedure |
No sound on one channel
BusMatrix™ DIP switch is not in the correct position. Check your configuration worksheet for the correct setting and verify.
Short circuit or loose wire at speaker or amplifier terminals. Check that connections are secure and that there are no loose strands of wire crossing from the positive to the negative terminal at the back of the amplifier and the speaker.
Short circuit or a break in the speaker wire. Disconnect the speaker wire at both ends, separate the 2 conductors at both ends and test with a meter for a short circuit. If there is no short, connect the two conductors at one end and test with a meter for continuity.
Speaker is not working. Connect the speaker to a channel that plays another speaker. Audio cable to dedicated input is bad. Connect the
Bridging Switch is in the wrong position. Check your configuration worksheet for the correct setting and verify.
The thermal protection circuit has operated because of overheating caused by over driving or inadequate ventilation.
No sound on some or all channels
BusMatrix™ DIP switches are not in the correct positions. Check your configuration worksheet and verify all settings.
Audio cable to the main bus inputs is bad. Connect the
|
| Hum may be caused by a ground loop between two components in the system. Test for a |
|
| Hum from all the | ground loop by reversing the AC plugs of any components in the system with non polarized AC | |
| plugs. | ||
| speakers | Check for faulty cables, faulty source material, an ungrounded phono system, cable TV feed or | |
|
| ||
|
| a defective component. | |
|
|
|
|
|
| Master power switch must be on. | |
| Amp will not turn on | AC power cord must be plugged into a working outlet. | |
|
|
| |
|
| Test that the AC power receptacle is working. If the outlet tests O.K., the internal fuses are | |
|
| blown. Return the amplifier to your dealer for service. | |
|
|
|
|
NILES AUDIO CORPORATION – |
| 27 |
|