Niles Audio SI-1230 manual INSTALLATION Considerations, Placement

Models: SI-1230

1 32
Download 32 pages 47.55 Kb
Page 17
Image 17
INSTALLATION Considerations

2 Channel, Bridgable Power Amplifiers

INSTALLATION Considerations

Placement

Place the SI-1230 on a flat, level surface like a table or shelf. It should be placed upright so that its weight rests on the unit’s four feet. PLACING THE WEIGHT OF THE AMPLIFIER ON THE REAR OR FRONT PANEL FOR EVEN AN INSTANT WILL RESULT IN DAMAGE TO THE AMPLIFIER’S CONNECTORS AND CONTROLS.

The SI-1230, like any hi-fi component, will last much longer if it is given adequate ventilation for proper cooling. When installing the SI-1230 in a cabinet, be sure that the rear of the cabinet is open to fresh air to provide proper cooling (see Figure 10). If the cabinet’s design will not accommodate an open rear, install two small “boxer fans” to provide continuous air flow into and out of the cabinet (see Figure 11). Place the SI-1230 so that there is at least 5” of free air space above the chassis. If the amplifier is located on a carpeted surface, place a board under the amplifier’s feet. Do not block the ventilation holes on the top and bottom of the SI-1230.

The SI-1230 is equipped with a digital power transformer. This transformer generates a powerful magnetic field which could induce hum in a turntable (particularly a turntable equipped with a moving coil cartridge). Do not place a turntable directly above or directly adjacent to the SI-1230.

Because the surface of the amplifier

may get hot, it

is recommended that a baffle

or screen be placed

above the amplifier to block

hand

access to the

top surface of the SI1230.

 

 

Make sure that there is a minimum of 7” of free air space above the amplifier for proper ventilation.

Boxer Fan (55 CFM) directly centered 7” on top of the Amplifier. Placement

Boxer Fan (55 CFM) directly centered 2” behind the Amplifier.

Allow a minimum of 2” of depth behind unit to accommodate cables and connectors.

If the cabinet rear is not open to fresh air or if you’re using low impedance loads, install two “boxer fans” to provide continuous air flow into and out of the cabinet.

NILES AUDIO CORPORATION – 1-800-BUY-HIFI1-760-710-0992

 

17

 

Page 17
Image 17
Niles Audio SI-1230 manual INSTALLATION Considerations, Placement