ENGLISH EN
MAINTENANCE
MAINTENANCE SCHEDULE
Maintenance Item | Daily | Monthly Yearly |
Charge Batteries | x |
|
Check/Replace Dust Bags | x |
|
Check/Replace Skirt | x |
|
Clean Pad | x |
|
Lubrication | x |
|
Check/Service Pad Motor Brushes | x |
|
Service Drive Motor Brushes | x |
|
BATTERY MAINTENANCE
Charge the batteries each time the machine is used for 1 hour or longer, or whenever the Battery Meter reads in the red area.
To Charge the Batteries...
1Remove cover.
2Plug charger in.
3Check the fluid level in all battery cells after charging the batteries. Add distilled water, if necessary, to bring the fluid level up to the bottom of the filler tubes.
CAUTION!
To avoid damage to floor surfaces, wipe water and acid from the top of the batteries after charging.
CAUTION!
Acid can spill onto the floor if the batteries are overfilled.
IMPORTANT
Motor damage resulting from failure to service carbon brushes is not covered under warranty. See the Limited Warranty statement.
SPECIFICATIONS
SPECIFICATIONS:
Model | ||
Power Supply | 36 volt |
|
Motor, Pad | 1.5 kW (2.0 hp) 55 amp |
|
Motor Traction | .37 kW (.5 hp) PM |
|
Drive System | Direct Drive |
|
Pad | 51cm (20”) |
|
Pad Speed | 1500 rpm |
|
Pad Pressure | Automatic | |
|
|
|
Speed, Forward | 0 - 73 m/min | |
Speed, Reverse | 0 - 52 m/min |
|
Vibration | <7.6 mm/s |
|
Sound Level (dbA) | 68 |
|
Drive Wheel | 4cmx20cm (1.62”x8.00”) |
|
Standard 36V, 21A | ||
Length | 127cm (50 inches) |
|
Width | 58cm (23 inches) |
|
|
|
|
Height | 105cm (41.25 inches) | |
Burnishing Swath | 51cm (20 inch) |
|
Polishing Rate | 2230 sq. m/hr. (24,000 sq. ft/hr) |
|
Weight (w/o batteries) | 79 kg / 174 lbs. | |
TROUBLESHOOTING
MACHINE VIBRATION
1Pad is not centered properly.
2Defective pad. Replace.
SWIRL MARKS
1Pad is too aggressive for the floor finish.
2Pad is dirty, Check and replace.
REDUCED RUNNING TIME
1Battery needs to be charged.
2Batteries need water. Add just enough to cover the plates in each cell. Then charge the batteries and check the water level again.
(E) PAD ASSIST MACHINE DOES NOT PULL ITSELF
For pad assist adjustment, follow the steps below (see steps 1 - 6 in Figure E):
1Tip burnisher back as shown to gain access to the pivot bracket.
2Remove the dust bag.
3Pull down on the dust skirt to gain access to the adjustment hard- ware.
4Lossen pivot bracket adjustment hardware and pivot bolts and rotate bracket counterclockwise to increase pad assist.
5Pivot braket has slots to allow adjustment.
6Adjust pivot bracket so pad is tipped down towards the RH side of the machine to increase the pad assist. Then retighten the adjust- ment hardware.
CAUTION!
Pad assist will vary depending on the aggressiveness of pad and the floor finish. If the deck is angled too much it could result in the pad burning the floor on the RH side.
