Nilfisk-Advance America 56316025 (R32-C) ENGLISH / A-13, After Use, Maintenance Schedule, Daily

ENGLISH / A-13

AFTER USE

1When finished scrubbing, press the Scrub Off Switch (B) twice, this will automatically raise, retract and stop all the machine systems (brush, squeegee, vacuum, solution and detergent (AXP/EDS models)). Then drive the machine to a service area for daily maintenance and review of other needed service up keep.

2To empty the solution tank, remove the Solution Drain Hose (4) from its storage clamp. Direct the hose to a designated “DISPOSAL SITE” and remove the plug. Rinse the tank with clean water.

3To empty the recovery tank, pull the Recovery Tank Drain Hose (21) from its storage area. Direct the hose to a designated “DISPOSAL SITE” and remove the plug (hold the end of the hose above the water level in the tank to avoid sudden, uncontrolled flow of waste water). Rinse the tank with clean water.

4Remove the brushes or pad holders. Rinse the brushes or pads in warm water and hang up to dry.

5Remove the squeegee, rinse it with warm water and re-install on mount.

6Remove the hopper on cylindrical systems and clean thoroughly. Remove from either side of the machine by opening the skirt and tilting the hopper up and away from housing, then pull out.

7Check the maintenance schedule below and perform any required maintenance before storage

MAINTENANCE SCHEDULE

MAINTENANCE ITEM	Daily	Weekly	Monthly	Yearly
Charge Batteries	X
Check/Clean Tanks & Hoses	X
Check/Clean/Rotate the Brushes/Pads	X
Check/Clean the Squeegee	X
Check/Clean Vacuum Shut-Off Float	X
Check/Clean the vacuum motor foam filter(s)	X
Clean Hopper on Cylindrical System	X
Check Each Battery Cell(s) Water Level		X
Inspect Scrub Housing Skirts		X
Inspect and clean Solution Filter		X
Check Foot/ Parking Brake For Wear & Adjustment		X
Clean Solution Trough on Cylindrical System		X
Purge Detergent System		X
Lubrication - Grease Fittings			X
* Check Carbon Brushes				X

*Have Nilfisk-Advance check the vacuum motor carbon motor brushes once a year or after 300 operating hours. The brush and drive motor carbon brushes check every 500 hours or once a year.

NOTE: Refer to the Service Manual for more detail on maintenance and service repairs.

8Store the machine indoors in a clean dry place. Keep from freezing. Leave the tanks open to air them out.

9Turn the Master Key Switch (J) OFF (O) and remove the key.

LUBRICATING THE MACHINE

Once a month, pump a small amount of grease into each grease fitting on the machine until grease seeps out around the bearings.

Grease fitting locations are:

•Squeegee Caster Wheel Axle

•Steering Wheel Shaft Universal joint

•Scrub Deck Caster Wheel Swivels (F) qty of 4 zerts (2 per castor).

Once a month, apply light machine oil to lubricate the:

•Steering Chain

•General Pivot Points For the Squeegee, Brush Linkage and Side Skirts

•Squeegee mount angle adjustment knob threads

Adhancer™ R28-C, R32-C / BR 800S TRIO EDS™ - 56041647 - A-13