A-14 / ENGLISH
CHARGING THE BATTERIES
Charge the batteries each time the machine is used, or whenever the Battery Condition Meter (K) is showing a yellow, red or flashing red indicator light(s).
WARNING !
Do not fill the batteries before charging.
Only charge batteries in a
Do not smoke while servicing the batteries.
When Servicing Batteries...
•Remove all jewelry.
•Do not smoke.
•Wear safety glasses, a rubber apron and rubber gloves.
•Work in a
•Do not allow tools to touch more than one battery terminal at a time.
To Charge the Batteries...
1Depress the Battery Disconnect (13).
2Open the Battery Compartment Cover (16) to provide proper ventilation.
3Push the connector from the Battery Connector (22) into the charger connector (Connector (29) if equipped with an onboard charger). Plug the AC line cord into a properly grounded wall outlet.
4Follow the instructions on the battery charger.
5Check the fluid level in all battery cells after charging the batteries. Add distilled water, if necessary, to bring the fluid level up to the bottom of the filler tubes.
CAUTION !
To avoid damage to floor surfaces, always wipe water and acid from the top of the batteries after charging.
CHECKING THE BATTERY ELECTROLYTE LEVEL
Check the electrolyte level of the batteries at least once a week.
After charging the batteries, remove the vent caps and check the electrolyte level in each battery cell. Use distilled water to fill the batteries to the bottom of the filler tube.
Do not
CAUTION !
Acid can spill onto the floor if the batteries are overfilled.
Tighten the vent caps. If there is acid on the batteries, wash the tops of the batteries with a solution of baking soda and water (2 tablespoons of baking soda to 1 quart of water).
