Nilfisk-Advance America IVB 5-H, IVB 7-H manual Replacing filter element, „H“ IVB 3-H

IVB 3-H

IVB 5-H

IVB 7-H

english	7.2.3 Replacing filter element
		„H“ (IVB 3-H)
		During the following work,
		ensure that dust is not
		unnecessarily	spread
		around. Wear	a P2
	breathing mask.

Never use the vacuum cleaner with- out a filter.

1.Clean the filter element (see 4.5).

2.Switch off the vacuum clean- er and wait approx. 5 minutes so that the dust can settle in the tank.

3.	Open the retaining clamps and
	remove the upper section of the
	cleaner from the dirt tank. Lay
	the upper section of the cleaner
	down with the filter element fac-
	ing upwards.
4.	Using the enclosed tool (2), turn
	the filter holder (1) anticlockwise
	and remove it.
5.	Place the protective filter bag

1	3
	2
	4
	6
5

	over the filter element (3).
6.	Carefully remove the filter ele-
	ment and close the protective
	filter bag with a knot.
7.	Clean the filter seal (4). Check it
	for damage and replace it if nec-
	essary.
8.	Check the antistatic clamp (5)
	for damage and have it replaced
	by Nilfisk-Advance Service if
	necessary.
9.	Fit a new filter element.

10.Check that the float (6) works properly. When the filter holder is turned, the float inside must move about easily.

11.Using the enclosed tool, attach the filter holder and turn it clock- wise to lock it.

12.Dispose of the used filter ele- ment in accordance with legal regulations.

7.2.4Replacing filter element „H“ (IVB 5-H/7-H)

During the following work, ensure that dust is not unnecessarily spread around. Wear a

1

3

2

P2 breathing mask.

Never use the vacuum cleaner with- out a filter.

1.Remove the upper section of cleaner from the dirt tank. Lay the upper section of the

4

cleaner down with the filter ele- ment facing upwards. Do not place the upper section of the cleaner on the guard (1) and do not damage the filter element.

2.Unscrew the screw (2), open the bar handle and remove it.

3.Remove the filter holder (3).

4.Place the protective filter bag over the filter element.

5.Carefully remove the filter ele- ment and close the protective filter bag with a knot.

6.Clean the filter seal (4). Check it for damage and replace it if nec- essary.

7.Check the antistatic clamp (5) for damage and have it replaced by Nilfisk-Advance Service if necessary.

12