Nilfisk-Advance America SR 1100S B manual Dust Filter Cleaning and Integrity Check

Models: SR 1100S B

1 100
Download 100 pages 29.32 Kb
Page 70
Image 70

ENGLISH

USER MANUAL

DUST FILTER CLEANING AND INTEGRITY

B

C

E

CHECK

 

 

 

NOTE

 

 

 

Besides the standard paper fi lter, polyester fi lters are

A

 

 

also available. The following procedure is applicable

 

A

to each type of fi lter.

 

 

1.Drive the machine on a level ground and engage the parking brake with the pedal (3) and the lever (4).

2.

Turn the ignition key (72) to "0".

D

3.

Disengage the hook (18) by pulling its lower end.

4.Remove the hopper (17) by using the handle (19) and by disengaging it from the inner guides.

5.Unscrew the knobs (33) and remove the fi lter compartment cover (32).

6.Loosen the knobs (A, Fig. 10).

7.

Disconnect the connector (B, Fig. 10) from the fi lter shaker

S311397

 

motor (C).

 

Figure 10

8.

Remove the dust fi lter fastening frame (D, Fig. 10).

 

9.

Remove the dust fi lter (E, Fig. 10).

A

10.

In an outdoor area, clean the fi lter by shaking it on a level

and clean surface, tapping the side (A, Fig. 12) opposite to the wire gauze (B).

Complete the cleaning procedure by using compressed air (C, Fig. 12) at maximum 6 Bars, blowing only from the side of the wire gauze (B), at a minimum distance of 30 cm.

Moreover, according to the fi lter type, observe the following cautions:

• Paper fi lter (standard): Do not use water or detergents to clean it, otherwise it can be damaged.

• Polyester fi lter (optional): For a better cleaning, it is allowed to wash the fi lter with water and non-lathering detergents. This provides better quality cleaning but

reduces the life of the fi lter, which will have to be

S311398

Figure 11

replaced more frequently. The use of inadequate

 

detergents can damage the fi lter.

 

11.Check the fi lter body for tears. If necessary, replace the

lter.

12.Clean the rubber gasket (A, Fig. 11) of the cover (32) and check it for integrity and effi ciency; if necessary replace it.

13.Assemble the components in the reverse order of disassembly, and note the following:

• Install the fi lter (E, Fig. 10) with the wire gauze (B, Fig.

12)facing upwards.

S311399

Figure 12

20

146 2494 000(2)2007-02 A

SR 1100S B

Page 70
Image 70
Nilfisk-Advance America SR 1100S B manual Dust Filter Cleaning and Integrity Check