Nilfisk-ALTO 520 Maintenance and repair, Accessories and spare parts, Recycling the steam cleaner

Models: 520

1 81
Download 81 pages 42.51 Kb
Page 4
Image 4
Maintenance and repair

STEAMTEC 520

english

Allow the cleaner to cool down

 

completely before storing it or

 

opening the safety catch.

 

Store the cleaner in a dry place.

 

CAUTION!

 

Unsuitable extension cords can

 

represent a source of danger.

 

Always unwind cord from the

 

reels completely to prevent the

 

power cord overheating.

Extension cords are not recom- mended, however if necessary refer to the following recom- mendations:

Cord length m

Cross section

 

 

 

up to 20 m

ø1.5mm²

ø2.5mm²

 

 

 

20 to 50 m

ø2.5mm²

ø4.0mm²

 

 

 

Do not damage the power cord (e.g. by driving over it, pulling or crushing it).

Disconnect the power cord by grasping the plug only (do not pull or tug the power cord).

Keep the power cord away from hot surfaces.

CAUTION:

Never immerse the cleaner or its parts in or under water or other liquids. Risk of electric shock.

The cleaner may only be con- nected to a correctly installed plug socket.

Switching on the cleaner may cause voltage fluctuations. Voltage fl uctuations should not occur if the impedance at the transfer point is less than 0.15Ω. If in doubt ask your local electricity supplier.

Observe the latest edition of the IEC regulations.

Maintenance and repair

CAUTION!

Always remove the plug from the power supply before clean- ing or carrying out maintenance work on the cleaner.

Carry out only the maintenance operations described in the operating instructions. Use only original Nilfi sk spare parts.

The power cord must not differ from the version specified by the manufacturer and may only be replaced by a repair service centre authorised by the manu- facturer.

Do not make technical modifi- cations to the cleaner.

Please contact your local authorized Nilfi sk equipment distributor for all other mainte- nance or repair needs!

Accessories and spare parts

Use only the accessories sup- plied with the cleaner or speci- fied in the operating manual.

Use original Nilfisk-spare parts only. The use of other parts can adversely affect safety.

Recycling the steam cleaner

Make the old clean- er unusable imme- diately.

1.Unplug the cleaner and cut the power cord.

Do not discard of electrical ap- pliances with household waste.

As specified in European Direc- tive 2002/96/EC on old electri- cal and electronic appliances, used electrical goods must be collected separately and recy- cled ecologically.

Contact your local authorities or your nearest dealer for further information.

Guarantee

Our general conditions of busi- ness are applicable with regard to the guarantee.

Subject to change as a result of technical advances.

Tests and approvals

The cleaner has been ap- proved in accordance with IEC/EN 60336-2-54.

Purpose

This cleaner is for domestic use only.

Only use the cleaner for the cleaning jobs described in the operating manual.

This cleaner is suitable for cleaning heat and moisture re- sistant surfaces.

Read the operating manuals for the machines and equipment that you clean as there may be limitations stated by the manu- facturer. Do not use the cleaner for ovens, microwaves, deep freezers, refrigerators and other electrical equipment.

CAUTION:

In the case of heat and mois- ture sensitive materials, make a test on a concealed place first. Begin with a low steam setting and keep a minimum distance of 6 cm. The high steam tem- perature/quantity may dam- age the object to be cleaned (e.g. varnished parquet, wood, wood ceilings, plaster, window frames, surface-treated wood, decorative beams, etc.).

2

Page 4
Image 4
Nilfisk-ALTO 520 Maintenance and repair, Accessories and spare parts, Recycling the steam cleaner, Guarantee, Purpose