CONNECTING THE MEDIAMASTER

Procedure when RF connections are used

This procedure is only necessary when your Mediamaster is connected to the TV with an RF lead and no SCART leads have been used.

To tune your TV to the RF signal, it is possible that you will need both this manual and the manual for your TV. The steps below explain what to do if you have been unable to use SCART leads in your connection.

Plug in your Mediamaster to the mains.

Tuning your TV to the Mediamaster

Select a programme number on the TV that is not currently used for other TV channels.

Follow the instructions in your TV manual to tune the TV channel selector to UHF channel 43 (this is the Mediamaster’s factory preset UHF channel).

Follow the instructions in your TV manual to store this UHF channel as the channel used by your Mediamaster. You will have to select it when you want to watch dig- ital terrestrial TV channels.

• When the First time installation menu is visible, press Select on the Mediamaster remote control to start the installation procedure.

If picture quality is bad, you can change the predefined UHF channel 43 to any other

number between 21 and 69 later on. You will also have to tune your TV to the new channel number. For more information, see RF modulator output channel on page

24.

When a VCR is connected, it must be tuned to a different UHF channel (between 21 to 69) than the Mediamaster.

GB 14