Frame Assembly
1.
Before beginning assembly, make sure you have read and understood the information on page 5. This brief introduction will save you much more time than it takes to read it.
Open the parts bag labeled “FRAME ASSEM- BLY.”
Press two 2” x 3” Inner Caps (24) into the ends of the Stabilizer (5). Press a 2” x 3” Inner Cap and a 2” Square Inner Cap (33) into the Main Upright
(3) in the indicated locations.
Insert three 3/8” x 3 3/4” Carriage Bolts (52) and a 3/8” x 5” Carriage Bolt (82) into the indicated holes in the Stabilizer (5).
Attach the Main Upright (3) to the Stabilizer (5) with the two indicated 3/8” x 3 3/4” Carriage Bolts
(52)and two 3/8” Nylon Locknuts (50). Do not tighten the Nylon Locknuts yet.
2.Press a 2” x 3” Inner Cap (24) into the end of the Base (8). Press two 2” Square Inner Caps (33) into the Leg Lever (29) and the front leg on the Base. Note: Do not fully insert the 2” Square
Inner Cap into the Base; it will need to be removed later to attach the Curl Post (not shown).
Attach the Base (8) to the Main Upright (3) with a 3/8” x 4” Bolt (65), a 3/8” Washer (55), and a 3/8” Nylon Locknut (50). The Bolt must be inserted from the side shown. Do not tighten the Nylon Locknut yet.
Slide two 5/16” x 3” Bolts (78) through the Base
(8) and the Main Upright (3), and hand tighten two 5/16” Nylon Locknuts (81) onto the Bolts. Do not tighten the Nylon Locknuts yet.
6
1 |
|
|
|
| 24 |
| 3 | 33 |
| 50 |
|
|
| 24 |
| 5 |
|
24 |
|
|
| 52 |
|
| 82 |
|
52 |
|
|
2 |
|
|
| 3 |
|
|
| 33 |
| 78 |
|
|
| 29 |
50 | 65 |
|
55 | 81 | 8 |
|
| |
| Front | 24 |
|
| |
| Leg |
|
