NordicTrack NCTL11990 user manual Left, Right

4. Place one of the Handrail Spacers (65) on the right						4	Cutout		A
Upright (69) as shown, with the cutout toward the tread-
mill (see inset drawing A). Pull the Upright Wire Harness							81
(98) up through the Handrail Spacer. Place the other
Handrail Spacer on the left Upright (not shown).								66			69
Have a second person hold the Handrails (66) near the											65
Uprights (69) as shown. Connect the Upright Wire							98	69	B	98
Harness (98) to the wires extending from the right
Handrail. Insert the connectors and the Wire Harness
(98) into the hole in the Console Base (81) (see inset
drawing B).
Be careful not to pinch the Upright Wire Harness (98) as							65
											81
you set the Handrails (66) on the Spacers (65).
5. Insert two Handrail Bushings (75) into the right Upright						5
(69). Turn the Handrail Bushings so they fit against the
Upright with the thick sides of the Bushings facing the									66
center of the treadmill as shown in the inset drawing.
Insert two Handrail Bolts (78) with Handrail Washers								65
									69
(77) into the Handrail Bushings (75), the right Upright
(69), and the right Handrail Spacer (65). Lift up the right									75
Handrail (66) to align the Bolts with the holes in the										77	Thick
Handrail. Next, thread the Bolts into the Handrail (66).											Side
Do not tighten the Bolts yet.
Attach the left Handrail (not shown) in the same way.							75	77		78
Tighten all four Handrail Bolts (78).
6. Look at the Rear Endcap (58). If the left or right foot on						6
the Endcap does not touch the floor, the included thick
base pads should be attached to the treadmill as de-
scribed below.
Refer to assembly step 3. Lower the treadmill frame
and the Uprights (69) as shown. If the				left	foot of the
Rear Endcap (58) was off the ground, remove the two
Base Pads (99) from the			right	Upright (69). Attach the
included thick base pads to the Upright. If the					right	side
of the Endcap was off the ground, attach the thick base						Left
						Foot	58
pads to the	left	Upright.
Note: If either side of the Rear Endcap (58) lifts off the											Right
floor when the treadmill is used, attach the thick base											Foot
pads as described.

7. Make sure that all parts are tightened before you use the treadmill.		Note: If there is a thin sheet of clear
plastic on the face of	the hood decal and the “ComforTrack” decal, remove it.	Keep the included allen wrench in

a secure place. The allen wrench is used to adjust the walking belt (see page 27). To protect the floor or car- pet from damage, place a mat under the treadmill.

7