9.Apply a small amount of grease to the axle on the Left Link Arm (30), to the axle on the Left Pedal Arm (32), and to a Wave Washer (100).
Slide the Wave Washer (100) onto the axle on the Left Pedal Arm (32). Next, slide a Link Arm Spacer (74) onto the axle on the Left Link Arm (30).
Then, insert the axle on the Left Link Arm (30) into the left Upper Body Leg (24) while sliding the Left Link Arm onto the axle on the Left Pedal Arm (32).
Repeat this step with the Right Link Arm (31).
10.Attach the Left Link Arm (30) to the Left Pedal Arm (32) with an M8 x 15mm Button Screw (106), an M8.5 x 16mm x 1.5mm Washer (103), and an Axle Cover (66).
Attach the Left Link Arm (30) to the left Upper Body Leg (24) with an M8 x 25mm Button Screw (110), two M8.5 x 16mm x 1.5mm Washers (103), two Axle Covers (66), a Link Arm Spacer (74), and an M8 x 15mm Button Screw (106) as shown.
Attach the Right Link Arm (31) in the same way.
9 |
|
|
|
| 24 |
|
|
|
|
| 31 |
Grease | 74 |
|
|
|
| 100 |
|
| 30 |
| 32 |
|
|
| |
|
| Grease | |
10 |
|
|
|
| 24 |
|
|
|
|
| 31 |
|
|
| 106 |
66 | 74 | 103 | |
66 |
| ||
103 |
|
| |
|
|
| |
110 |
|
|
|
|
| 30 |
|
|
| 106 | 66 |
|
| 103 | |
|
|
| 32 |
11.Plug the power cord (not shown) into the power socket (not shown) at the rear of the elliptical exer- ciser.
Make sure that all parts of the elliptical exerciser are properly tightened. Note: Some hardware may be left over after assembly is completed. To protect the floor or carpet from damage, place a mat under the elliptical exerciser.
9
