MAINTENANCE AND TROUBLESHOOTING
Inspect and tighten all parts of the elliptical exerciser regularly. Replace any worn parts immediately.
To clean the elliptical exerciser, use a damp cloth and a small amount of mild soap. Important: To avoid damage to the console, keep liquids away from the console and keep the console out of direct sunlight.
HOW TO LEVEL THE ELLIPTICAL EXERCISER
HOW TO ELIMINATE FLEXING IN THE CENTER OF THE ELLIPTICAL EXERCISER
If the elliptical exerciser flexes in the center during use, turn the center foot beneath the frame (see the drawing at the left) until the flexing is eliminated.
HOW TO ADJUST THE BELT
If the pedals slip |
while you are |
If the elliptical exerciser rocks on your floor dur- ing use, turn one or both of the leveling feet beneath the rear stabilizer until the rocking motion is elimi- nated.
Center
Foot
Leveling 
Feet
pedaling, even |
|
while the resis- |
|
tance is adjusted |
|
to the highest |
|
setting, the belt |
|
may need to be |
|
adjusted. To | 13 |
adjust the belt, | 12 |
first carefully pry |
|
off the left Disc |
|
Cover (13) using a flat screwdriver. Next, remove the four screws (not shown) from the center of the left Disc (12). Gently rotate the Disc Cover and the Disc
HANDGRIP PULSE SENSOR TROUBLESHOOTING
•Avoid moving your hands while using the handgrip pulse sensor. Excessive movement may interfere with heart rate readings.
•Do not hold the metal contacts too tightly; doing so may interfere with heart rate readings.
•For the most accurate heart rate reading, hold the metal contacts for about 30 seconds.
•For optimal performance of the handgrip pulse sen- sor, keep the metal contacts clean. The contacts can be cleaned with a soft
away from the elliptical exerciser.
Loosen, but do |
| |
not remove, the |
| |
three 1/4" x |
| |
19mm Button |
| |
Screws (114). |
| |
Insert the shaft of | 47 | |
a screwdriver | ||
48 | ||
downward | ||
114 96 | ||
between the | ||
Idler (47) and the |
| |
Idler Pulley (48). |
| |
Pull the top of the |
| |
screwdriver |
|
toward the rear of the elliptical exerciser until the Belt (96) is tight, and then tighten the three Button Screws.
Reattach the left disc with the four screws and then reattach the left disc cover.
21
