6.Scan and save channels.
Select CATV or AIR. Select CATV to receive chan- nels through the 75 ohm terminal on the treadmill. Select AIR to receive channels through an antenna. To scan for available channels, highlight AUTO SCAN or AUTO SCAN ADD CH. To scan all chan- nels, select the Auto scan option. To scan all chan- nels and add an extra channel, select the Auto Scan Add Ch option. The scan channel submenu will appear.
If you are receiving channels through a CATV cable, high-
light CABLE SYS- Cable SystemAUTO
TEM and select the Start to Scan auto, STD, IRC, or
HRC setting. Try all UP/DOWN ADJUST "MENU": EXIT
four cable settings, if necessary, to find the optimal setting.
Highlight START TO SCAN and press the Volume increase button to start the auto scan. The televi- sion will begin scanning all of the channels avail- able in your area. When no signal is detected on a channel, the channel will be skipped. When a sig- nal is detected, the channel will be saved into memory and the next channel will be selected. This process will continue until the highest channel is reached. The television will renumber the channels in the order in which it locates them. Do not re- move the key while the television is scanning channels. Note: If a television channel disappears, scan for channels again.
After all valid chan- |
|
|
|
|
nels available in your |
|
|
|
|
area have been | No. | Program Name | Skip | |
saved into the televi- | FD 3803 |
| Off | |
Off | ||||
sionʼs memory, you |
|
|
|
|
can manually skip |
|
|
|
|
unwanted channels. | "ENTER": SELECT | "MENU": EXIT | ||
To skip a channel, |
|
|
|
|
highlight CHANNEL |
|
|
|
|
SKIP and press the Volume increase button on | ||||
your remote control. In the channel skip submenu, | ||||
press the Channel increase and decrease buttons | ||||
to highlight the desired channel and the Volume in- | ||||
crease and decrease buttons to turn on or turn off | ||||
the skip option. Continue this process until you | ||||
have skipped all unwanted channels. |
|
| ||
To change the dis- |
|
|
|
|
play name of a chan- |
|
|
|
|
nel, highlight CHAN- |
|
|
|
|
NEL NO. and select |
|
|
|
|
a channel. Then, | F D | 3 | 8 | 0 3 |
highlight CHANNEL |
|
|
|
|
LABEL and press the | EDIT | SELECT | "MENU": EXIT | |
Volume increase but- |
| 4 5 6 |
| |
ton to enter the |
|
|
|
|
channel label submenu. Press the Volume in- crease and decrease buttons to select a number or letter box. Then press the Channel increase and decrease buttons to select the desired number or letter.
7.Exit the Menu.
When you have finished adjusting the settings, press the Exit button.
27
