ASSEMBLY
Assembly requires two persons. Set the treadmill in a cleared area and remove all packing materials. Do not dispose of the packing materials until assembly is completed. Note: The underside of the treadmill walking belt is coated with
Assembly requires the included hex key and your own Phillips screwdriver | and adjustable | |
wrench | . Use the drawings below to identify the assembly hardware. The number in parentheses | |
below the drawing is the key number of the part, from the PART LIST near the end of this manual. The number after the parentheses is the quantity needed for assembly. Note: If a part is not in the hardware kit, check to see if it is preattached to one of the parts to be assembled. To avoid damaging plastic parts, do not use power tools for assembly. Extra hardware may be included.
3/8" Nut | 3/8" Star Washer | #8 x 3/4" | 3/8" x 1 1/4" |
Tek Screw | Bolt | ||
3/8" x 1 3/4" Bolt | 3/8" x 2" Bolt | ||
| 3/8" x 3 3/4" Bolt |
| |
1. Make sure that the power cord is unplugged. | 1 |
With the help of a second person, raise the front |
|
of the treadmill and insert the crossbar on the |
|
Base (83) into the cutout in the cardboard stand |
|
as shown. Serious injury may occur if the |
|
treadmill moves forward or backward and |
|
falls off the cardboard stand. A second per- |
|
son must hold the treadmill until assembly |
|
step 2 is completed to prevent the treadmill |
|
from moving, tipping, or falling. |
|
WARNING: Serious injury | 83 |
may occur if the treadmill moves for- | |
ward or backward and falls off the card- |
|
board stand. A second person must |
|
hold the treadmill until assembly step 2 |
|
is completed to prevent the treadmill | Cardboard |
from moving, tipping, or falling. | |
| Stand |
| 7 |
