FRAME ASSEMBLY
ARM ASSEMBLY
11.Attach the Leg Press Plate (11) to the Adjustment Tube (10) with a 5/16” x 2 1/2” Bolt (39), two 5/16” Washers (20), and a 5/16” Nylon Locknut (40). Be sure that the Leg
Press Plate and Adjustment Tube are ori- ented as shown.
Press a 1 3/4” Square Inner Cap (48) into the Adjustment Tube (10).
12.Attach the Adjustment Tube (10) to the Leg Press Arm (9) with the Lock Pin (73). Be sure the Leg Press Plate (11) is oriented as shown.
Press two 2” Square Inner Caps (56) into the Leg Press Arm (9).
13.Locate and open the parts bag labeled “ARM ASSEMBLY.”
Attach the Leg Press Bumper (53) to the Front Seat Frame (8) with the 1” Tap Screw
Lubricate the 3/8” x 3 1/4” Bolt (71). Attach the Leg Press Arm (9) to the Press Base (13) with the Bolt and a 3/8” Nylon Locknut (42).
14.Press a 1” x 7/8” Plastic Bushing (54) onto each welded spacer on the Press Frame (12). Slide the Press Frame onto the Press Base
(13)so that the Plastic Bushings are aligned with the indicated tube. Note: This will be a tight fit. Make sure that the high pulley is on the side shown.
Lubricate the 3/8” x 8” Bolt (52). Attach the Press Frame (12) to the Press Base (13) with the Bolt and a 3/8” Nylon Locknut (42).
9
11 |
| |
| 10 | |
| 40 | |
48 | 20 | |
| ||
39 |
| |
| Angle | |
| 11 | |
12 | 10 | |
73 | ||
| ||
| 11 | |
| 9 | |
| 56 | |
13 |
| |
| 8 | |
| 9 | |
| 53 | |
| 42 | |
| 72 | |
| ||
| 13 | |
14 |
| |
| Tube | |
High | 12 | |
Pulley |
| |
Welded | 13 | |
| ||
Spacers | ||
| ||
42 | 54 | |
|
