Locate the Reed Switch (49) and the Magnet (37) on | Top |
|
the left side of the Pulley (38). Turn the Pulley until the |
| |
Magnet is aligned with the Reed Switch. Make sure | View |
|
that the gap between the Magnet and the Reed | 1/8 in. |
|
Switch is about 1/8 in. (3 mm). If necessary, loosen | 37 | |
the #8 x 3/4" Clamp Screw (13), move the Reed | 13 | |
Switch slightly, and then retighten the Screw. | 49 | 38 |
Reattach the Left Roller Cover (not shown) and run | ||
the incline trainer for a few minutes to check for a cor- |
|
|
rect speed reading. |
|
|
PROBLEM: The incline of the incline trainer does not change correctly
SOLUTION: a. Hold down the Stop button and the Speed increase button, insert the key into the console, and then release the Stop button and the Speed increase button. Press the Stop button again. Then, press the Incline increase or decrease button. The incline trainer will automatically rise to the maximum incline level and then return to the minimum level. This will recalibrate the incline sys- tem. If the incline does not calibrate, press the Stop button, and then press the Incline increase or decrease button again. When the incline is calibrated, remove the key from the console.
PROBLEM: The walking belt slows when walked on
SOLUTION: a. Use only a
formance may decrease and the walking belt may be- come damaged. Remove the key and UNPLUG THE POWER CORD. Using the hex key, turn both idler roller bolts counterclockwise, 1/4 of a turn. When the walking belt is properly tightened, you should be able to lift each edge of the walking belt 3 to 4 in. (8 to 10 cm) off the walking platform. Be careful to keep the walking belt centered. Then, plug in the power cord, insert the key, and run the incline trainer for a few minutes. Repeat until the walking belt is properly tightened.
c. If the walking belt still slows when walked on, please see the front cover of this manual.
22
