Nortec 132-3091 manual Receiving & Unpacking Equipment, Pre-Installationcheckpoint

INSTALLATION

RECEIVING & UNPACKING EQUIPMENT

1.Check packing slip to ensure ALL material has been delivered.

2.All material shortages are to be reported to NORTEC within 48 hours from receipt of goods. NORTEC assumes no responsibility for any material shortages beyond this period.

3.Inspect shipping boxes for damage and note on shipping waybill accordingly.

4.After unpacking, inspect equipment for damage and if damage is found, notify the shipper promptly.

5.All NORTEC products are shipped on an F.O.B. factory basis. Any and all damage, breakage or loss claims are to be made directly to the shipping company.

PRE-INSTALLATION CHECKPOINT

1.Ensure that available voltage and phase corresponds with humidifier voltage and phase as indicated on humidifier’s nameplate label (see Figure #1).

2.Ensure that the dedicated external disconnect is of sufficient size to handle the rated amps as indicated on the nameplate label. Refer to local codes.

Figure #1

NH Series Humidifier

Condensate Steam

Return Outlet

		Power And
		Control
Drain	Nameplate	Wiring
	Label
	Water
	Supply

3.Report any discrepancy immediately.

BASIC HUMIDIFIER CONFIGURATION

NORTEC humidifier models NHMC, NHP and NHB share a modular sheet metal cabinet. Each unit has a right side electrical compartment. Each electrical compartment has a hinge-down front door which is removable from any partially or fully opened position. Each electrical compartment has a screw-mounted right side cover which can also be removed for ease of electrical connection. For safety, the door when closed keeps the side cover from being removed.

Single units have a plumbing compartment attached to the left side of the electrical. Double units have a second plumbing compartment. Each plumbing compartment has a hinge-down front door which is not intended to be removed. For safety, the door must be closed in order to engage the shared lock. To avoid any danger, never operate the humidifier with a door off. For safety, each door when closed engages its own safety interlock switch. All switches must be engaged before the unit will operate.

To open the doors, unlock key, lift door up slightly and pull top of door forward. Door will hinge 180 degrees and hang straight down. To remove door, swing door parallel to floor. Then lift up slightly and out. To reinstall door, hold parallel to floor and insert hinge pins at bottom.

Figure #2

Clearance Requirements

WALL
WITHOUT BLOWER PACK
TOP VIEW
	MIN. 36" SIDE
	CLEARANCE
	RECOMMENDED.
	SEE NOTE.
NOTE: LOCAL AND NATIONAL
CODES MAY DEVIATE. PLEASE	MIN. 36"
CONSULT APPLICABLE CODES	FRONTAL
FOR CLEARANCE REQUIREMENTS	CLEARANCE.
IN ALL CASES.

- 1 -