M.DRAIN WATER SUMP PUMP
(1)Externally mounted below humidifier. For use when no floor drain is available and water must be pumped higher than the bottom of the humidifier (special high temperature model). Rated for use with all GS models. Recommended model: W.W. Grainger #4RD29 or #4RD32.
N.STEAM DISTRIBUTION
(1)Used in ducts or air handling units, available in stainless steel.
(2)Steam is dispersed through evenly spaced outlet orifices and upward perpendicular to the airflow.
(3)When steam is dispersed through evenly spread outlet orifices that are along the steam distributors “active zone”. They are offset 45º from vertical to address potential static pressure induced by downward airflow. The distributor is rotated when installed.
O.REMOTE MOUNTED BLOWER PACK
(1)RMBP
(2)Direct steam distribution system that allows for direct space/room humidification when steam introduction into a ducted system is not feasible. The factory assembled Blower Pack includes integral steam distributor, an internal steam hose and condensate connection for simple installation including 3 individual 110 cfm blower fans that can be powered by a separate 115 V single phase power supply or can be ordered with a factory installed step down transformer for all standard primary voltages. The Blower Pack features an adjustable fan to provide different angles allowing for a flexible install. A temperature sensor enables fans when steam production begins, while maintaining a quiet operational environment. The Remote Mounted Blower Pack ships fully assembled and ready for easy installation with NH, GS, SE Technologies.
(3)See Blower Pack distribution for more information.
P.SHORT ABSORPTION MANIFOLD
(1)See Short Absorption Manifold Engineering Manual for model numbers.
Page 26
