Nortel Networks ICS 4.1 Show DstCode, AbsorbLength, Evening Lunch Sched SchedNight, Overflow

Page 62

••• Show DstCode:_	Up to 500 destination codes are programmable.
	Enter the digits (up to 7 digits) of the destination code that you want to define. No two
	destination codes can be identical. A destination code cannot begin with a digit assigned as
	the Call Park prefix, or a Direct-dial digit. It cannot be the same as, or be the start digits of a
	DN, the DISA DN or the Auto DN, a line pool code, or a received number.
•••• Normal	For the last destination code, define the normal service. You will usually use the route that has
	the lowest cost for the times when normal service is in use.
•••• AbsorbLength	Enter the number of digits from the destination code that will not be dialed as part of the
	outgoing number.
•••• Night	For this destination code, define a route for each of the schedules, as you have done for normal
	service.
•••• Evening
•••• Lunch
•••• Sched 4
•••• Sched 5
•••• Sched 6
•• Sched:Night	This schedule can be activated automatically or manually, or it can be left in the default Off.
••• Service	Select how you want this service activated, if applicable.
••• Overflow	For each schedule, choose whether you want a destination code to use the route assigned to
	normal service when the route assigned to the schedule is busy.
•• Sched:Evening	Select how you want each of the scheduled services to be activated, and whether a destination
	code uses the route used with normal service when the route used with the schedule is busy.
•• Sched:Lunch
•• Sched:Sched 4
•• Sched:Sched 5
•• Sched:Sched 6
• Common settings	In this programming section, you can assign settings that are shared by different services.
•• Control sets	Assign control telephones to turn services on or off.
••• For lines	Select a control set for each line.
•••• Show line:_	Enter the number of the line you want to program.
••••• L001	Assign a control telephone to each external line. This telephone is where you turn services on
	and off for the line.
••• For sets	Select a control set for each set.
•••• Show set:_	Enter the number of the telephone you want to program.
••••• <internal #>	Assign a control telephone to each telephone. This telephone controls Restriction service and
	Routing service for the set.
•• Schedule names	The schedule name is shown on the display of the control telephone when the schedule is turned
	on. It identifies the active schedule.

Compact ICS 4.1 Programming Record P0906186 Issue 02