Nortel Networks Confidential | Configuration Management 31 |
|
|
Figure 6 SimRing configuration procedure flow
Enable | Assign | View |
SimRing | SimRing | SimRing |
on switch | to a line | status |
Enabling SimRing on the DMS
Before adding SimRing to a line, make sure that table OFCENG is datafilled properly in order for SimRing to work. Sample datafill is shown below:
>TABLE OFCENG
MACHINES NOT IN SYNC - DMOS NOT ALLOWED JOURNAL FILE UNAVAILABLE
-DMOS NOT ALLOWED TABLE: OFCENG
>POS SIMRING_RES_CONTROL
SIMRING_RES_CONTROLY N
>POS SIMRING_CENTREX_CONTROL SIMRING_CENTREX_CONTROLY N
>POS NO_OF_CLONE_TIDS NO_OF_CLONE_TIDS 20
For detailed engineering information about configuring these OFCENG tuples correctly, please refer to the North American
Assigning SimRing on a DMS line
To assign SimRing to an existing line, use the EST (establish) command of SERVORD.
>SERVORD |
|
|
SO: |
|
|
>EST |
|
|
SONUMBER: | NOW | 0 8 16 PM |
>$ |
|
|
GROUPTYPE: |
|
|
>SIMRING |
|
|
SIMRING_PILOT_LEN: >HOST 0 1 10 5
SIMRING_MEMBER_DN: >6215115
SIMRING_MEMBER_DN: >6215010
SIMRING_MEMBER_DN: >$
SIMR_STATE: INACT
Copyright © 2003, Nortel Networks | MCP Interworking Basics |
