16Chapter 4 Configuring BST Doorphone settings
Table 4 BST Doorphone settings (Sheet 2 of 2)
Setting | Values | Description | ||
|
|
| ||
Page Target | Internal | Internal: Make a page announcement to a specific group of | ||
|
|
| External | telephones in a page zone, through the telephone speakers. |
|
|
| Both | External: Make a page announcement through an external |
|
|
|
| |
|
|
|
| loudspeaker system. |
|
|
|
| Both: Make a page announcement through telephone |
|
|
|
| speakers and an external loudspeaker system. |
|
|
| ||
Page Zone | Zone (1 to 6) | Assign Doorphone paging to one of six page zones. | ||
|
|
| All | Select All to assign Doorphone paging to all six page zones. |
|
|
|
| |
|
|
| ||
Chime Sequence | 1 to 4 | During a Doorphone page, a page tone will be heard followed | ||
|
|
| None | by the distinctive chime. |
|
|
| Custom | Select one of four standard distinctive chimes. |
|
|
|
| |
|
|
|
| Select None to have no chimes presented during a Doorphone |
|
|
|
| page (only a page tone will be heard) |
|
|
|
| Select Custom for an unique chime setting. You must enter a |
|
|
|
| custom chime sequence in the Custom Chime setting. |
|
|
| ||
Custom Chime | < 0 to 8 digit string> | Allows you to create your own chime tune using the following | ||
|
|
|
| parameters: |
|
|
|
| 0 to 4 - chime tone (pitch) increases by number |
|
|
|
| 5 = silence |
|
|
| ||
Opener Type | DOC | Allows you to specify if a Door Opening Controller (DOC) is | ||
|
|
| None | connected to the Doorphone. |
|
|
| ||
Open Digit | 0 - 9, * or # | The Open digit setting allows you to specify a single digit code | ||
|
|
| < | to unlock a door or gate when a DOC is connected to the |
|
|
|
| Doorphone. |
|
|
|
|
|
|
|
| Note: |
|
|
|
|
| |
|
|
| The Open digit setting must match the | |
|
|
| ||
|
|
| information on DOC, refer to Optional Equipment on page 13. | |
|
|
| ||
Hardware ID | <10 character string> | This | ||
|
|
|
| number assigned to the Doorphone. |
|
|
|
|
|
Testing the BST Doorphone
You can perform the following tasks to test the Doorphone settings:
•Press the Call button on the BST Doorphone and ensure the Target DN telephone rings.
•Let the Target DN telephone ring until the call is automatically disconnected. Ensure that a page tone followed by the Doorphone’s distinctive chime is heard at specified telephones included in the Doorphone’s page zone.
•To establish a voice path, dial the BST Doorphone’s DN from any telephone on the system, or press the Call button on the BST Doorphone and answer the ringing call at the Target DN telephone.
•If installed, test the DOC as shown below:
—Press the Call button on the BST Doorphone and answer the call at the Target DN telephone.
