II.) Assembly Instructions
To attach handles, use: 5/16 X .75” Flange Bolts (4x) 5/16 Flange Nuts (4x)
To attach wheels:
1.) Slide 5/8 X 3.5” bolt through hub of wheel.
2.) Spin 5/8 Jam Nut onto bolt. Do not tighten against wheel. 3.) Slide bolt through hole in frame, secure with 5/8 Hex Nut.
5/8 Hex Nut
5/8 Jam Nut
5/8 X 3.5” Hex Bolt 
1.Attach handles, see above.
2.Attach wheels, see above.
3.Remove water heater from the pallet. It is recommended that a hoist is used, or that two people lift the unit off of the pallet. If a hoist is used, use the attachment points shown in the Moving and Handling section on page 16. Do not try to lift the unit by the hook on the heating coil inside the heat exchanger. The heating coil is not secured to the frame.
8
