Numark Industries CDMIX3 Quick Setup, Read Safety Instruction Booklet Before Using the Product

CDMIX3 QUICK SETUP

1.Make sure all items listed on the front of this guide are included in the box.

2.READ SAFETY INSTRUCTION BOOKLET BEFORE USING THE PRODUCT.

3.Study this setup diagram.

4.Place CDMIX3 station in an appropriate position for operation.

5.Make sure all devices are turned off and all faders and gain knobs are set to “zero”

6.Connect all stereo input sources as indicated in the diagram.

7.Connect the stereo outputs to power amplifier(s), tape decks, and/or other audio sources.

8.Plug all devices into AC power.

9.Switch everything on in the following order:

•audio input sources (i.e. turntables or CD players)

•CDMIX3

•last, any amplifiers or output devices

10.When turning off, always reverse this operation by,

•turning off amplifiers

•CDMIX3

•last, any input devices

11.Go to http://www.numark.com for product registration.

More information about this product may be found at

http://www.numark.com

REAR CONNECTIONS

1.Channel Inputs: Unbalanced RCA jacks for connecting external sources. The Phono/Line input is selected using the toggle switch on the front panel. Turntables, HiFi VCRs, cassette and reel-to-reel tape decks, DAT machines, CD players, laser discs, tuners, even synthesizers or other mixing consoles can be connected using these jacks. NOTE: Plug mono audio sources into both left and right inputs using a “Y” cable connector.

2.GND: This screw connector should be used to connect any turntables or other devices that need to be grounded.

3.Line/Phono Input Switch: Use this to allow either line level or phono level equipment to be plugged into your channel inputs. When Phono input is selected, your signal is fed directly to the high-quality RIAA phono pre-amplifiers.Use this position only for

turntables. Line level sources will overload the sensitive phono pre-amps and will sound very bad, so always be sure to toggle the line/phono switch over to line before connection of line sources.

4.Third Line Input: Plug in a third line level device such as a tape deck or additional CD player here.

5.Stereo Master Outputs: Unbalanced RCA connectors controlled by the Master fader.

6.Stereo Balanced Master Outputs (XLR): low- impedance XLR type connectors controlled by the Master fader.

7.Mic Input: Plug your 1/4” Microphone plug in here.

8.AC In: This mix station is designed to work with the power supply cord that comes with the unit. While the power is switched off, plug the power supply into the mix station first, then plug it into the outlet.